29.3mm EXHAUST VALVE TRIPLE GROOVE COLLET 1.149"

Valve Guides - Materials and Useage

Material choices for guides are down to two distinct types - cast iron and bronze. Yes, cast iron. NOT steel as described in many adverts and by vendors. Never have been, never will be. These are as fitted to the various A-series cylinder heads as standard in all applications. Cast iron is used because it is a very dissimilar metal from any used in valve manufacture - important to eliminate galling that causes seizure of the valves in the guides - is softer, yet resilient enough to wear well. Bronze, on the other hand, is a very general description as there are a variety of 'bronzes' used by various folk. In days gone by, the bronze base type used was 'PB1' (also known as 'Navy Bronze') - a phosphor-bronze alloy that was very orange in colour, and very soft, used primarily in race engines. Unfortunately they wore out very quickly. Silicone-brass content bronze is probably the most popular now - often with a high aluminium or manganese content - is very yellow/gold in colour.

Engine - Small-bore engine, 12G940 head fitting

There is no specific large-bore (1275cc-based) head casting number that will fit the 998 engine any easier than any other.

They all have the same problems - generally requiring exhaust valve relief cut-outs machined into the block and re-alignment of the front water gallery transfer ports. However, I would avoid using heads with valves bigger than 35.7mm on the intake since these are too big for most 998 engines unless they are absolutely full-race spec where top end power at high rpm is all that is required.

First of all it is worth checking that you actually need to make the relief cut-outs since some heads have a big enough head face to exhaust valve face clearance to allow fitment without the cut-outs when the standard cam and rocker gear is retained.

If possible, measure the actual valve lift you are getting with the current fitted set-up.

Valve guides - Materials and usage

Material choices for guides are down to two distinct types - cast iron and bronze. Yes, cast iron. NOT steel as described in many adverts and by vendors.

Never have been, never will be. These are as fitted to the various A-series cylinder heads as standard in all applications. Cast iron is used because it is a very dissimilar metal from any used in valve manufacture - important to eliminate galling that causes seizure of the valves in the guides - is softer, yet resilient enough to wear well. Bronze, on the other hand, is a very general description as there are a variety of 'bronzes' used by various folk. In days gone by, the bronze base type used was 'PB1' (also known as 'Navy Bronze') - a phosphor-bronze alloy that was very orange in colour, and very soft, used primarily in race engines.