This pipe kit is for converting Metro 4 pot callipers with dual feed pipes to a single feed as used on minis.

It is necessary however, to check that this is permitted by the legislation in the country in which the vehicle is to used. To ensure maximum pipe clearances, the main feed pipe should be screwed into the lower of the feed holes, through one end of the link pipe. The other end of the link pipe should then be connected to the calliper by one of the banjo bolts provided.

Ensure a copper washer is fitted on either side of the banjos to effect a fluid tight seal. The link pipe should be curved towards the front of the calliper (away from the calliper to the hub mounting bolts). The end of the feed pipe with the large union can be connected to the subframe in the usual way.