Contains following;
TAM1521 head gasket, inlet/exhaust manifold gasket, rocker cover, heater valve, 2 x thermostat, 3 x
HS4 carb to manifold, 6 x
HS2 carb to manifold, 2 x
HS2 carb to aircleaner, 3 x hif carb to manifold, 1 x HIF to aircleaner, 4 x inlet valve stem seals.
SEE
AJM1141MS for same set but with the performance
AF460 PAYEN copper head gasket therefore this kit will fit any 1275cc whether single HIF38/44 carb or
HS2/4 type. This is Minispares ultimate standard gasket set for 1275cc engines, containing the the black type production head gasket used by Rover.
GEG202 is engine conversion set and
GEG804 is transmission set for Minis.
-Thoroughly clean both surfaces, check head and block is flat with straight edge and feeler gauges.
-install studs into block hand, tightened and oil the the threads
-install new gasket dry onto block over studs
-install head and rocker shaft, confirm it not fouling on anything.
-tighten head nuts in the correct sequence incrementallly 5foot pounds at a time, up to 45 foot pounds total and triple check all are at correct torque. Follow minispares product instructions for washers to be used on the front studs only.
-check valve clearances
-Start engine without coolant for 2-3 minutes
-leave to cool down for around 1 hour
-fill with coolant
-restart engine