C-AHT772 (3.75”, C-AHT773 (5”), C-AHT774 (6”) WEBER INLET MANIFOLD KIT
Build the manifold up before fitting to the car. The two spherical ended joints screw into the inlet manifold using the flat washers and nuts to lock them into place. The 5/16” rod is a tight fit into the two joints and care must be taken when fitting. The two linkage brackets fit either end of the 5/16” rod outside of the spherical joints using the 5mm nut and bolt to secure.
Fit the small rose joints either end of the threaded rod and fit to the throttle linkage on the side required for the Weber carb being used.
The 5” metal bar fits in a vertical position to the manifold, secured on the original manifold studs when fitting to the engine.